With your Twist (version > 1.4.3) connected to the Webapp, after
replacing the Master Board, you can set the Twist type here.
This is required to safely replace the Master Board in the Rear-only Twist.
Change Serial Number
With your Twist (version > 1.4.3) connected to the Webapp, after
replacing the Master Board, you can change the Twist serial number here.
This is required to activate the device traceability again.
New Serial Number has wrong format
Reset Steering Sensor Center
Reset the Zero value of the steering sensor of the Twist. The steering sensor is used
to
reduce the speed of the wheel during turns using the Controller.
WARNING: When this operation is performed the top part of the
Twist
needs to be centered and the Twist should be on a flat surface.
After the operation is completed the Twist will play a sound (if not disabled).
The Twist needs to be restarted for the change to take effect.
Twist Rear-mounted Gear Speeds
With your Twist (version > 1.4.0) connected to the Webapp, you
can use this
feature to enable/disable the 10km/h speed mode for the rear-mounted Twist.
The setting chosen will be saved on the device and will remain active after the Twist is
restarted.
Maintenance and Service
In this page you can find the maintenance and service information for your Klaxon device.
For additional information always refer to the Twist
User Manual or the dealer that sold you the Twist.
Service Intervals
For the Klaxon Twist regular maintenance should happen every 2
years or 1000km.
The tire should be changed every 3 years or when the tread is
worn out.
The battery should be replaced every 5 years or when the charge
capacity is below 70%.
Next planned service
Your Twist has been produced on 2023-01-15.
Currently the Twist has driven 0
km.
The next planned service is on 2025-01-15 or after 1000 km.
Drive Profiles
Select your Drive Profile or edit the settings and
save
them in the Custom Profile
Gestione modalità spinta assistita
Forza da imprimere alla ruota per
partire
Forza d'arresto improvvisa
necessaria
per frenare il Twist
-
Gestione controller
Modalità
Forza del freno elettronico
-
Gestione guida con manubrio
Modalità
Freno elettronico
Freno motore
Velocità massima (km /
h)[= mph]
-
Velocità
massima (km / h)
[=mph]
-
-
Gestione guida con
accompagnatore
Electronic Brake strength
Max Gear
Speed
-
Electronic Brake Level
0
Acceleration Level
0
Motor Brake Level
0
Reverse gear speed
0
Speed Limit
0
Password On or Off
Device type not recognized
0%
Please select the update type
Logs:
Firmware Update
•
For information regarding the update process
please refer to the Twist
Update Manual
The latest Twist version available is:
No update is available for your Twist right now. When an update is available you will be
notified.
Warning: This update requires two separate steps to complete.
To update follow the procedure presented in this page, after the first step is complete
you
will need to repeat it again to complete the update.
Warning: After you complete the first step the Twist will not be working until you
complete the second and final step.
Please make sure that the battery is above 20% and that you have a stable internet
connection.
Twist update ready to start, please
connect to the Twist Access Point to continue
Update the device firmware, after the update is
complete it is necessary to restart the Twist.
Not connected to
Twist
Update
Progress:
0%
Upload to device complete, now you can restart the
Twist
Twist information
Model:
Serial
Number:
-
Twist information
not
available. First you need to connect your
Twist to the Webapp to see this information.
Twist:
0.0.0
Drive:
0
Parameters:
0
Controller:
0.0.0
Handlebar:
0.0.0
Caregiver:
0.0.0
Command Pairing
Manage the pairing of the Twist's Bluetooth commands.
By
using this
feature you declare to be an authorized
Klaxon dealer and accept all consequences should this not be the case, you need to be
connected
to the Twist to use this feature.
Controller Notification Sound settings
Enable/Disable the sound that is played when changing gear or braking when using the Base
Command.
Acoustic Warnings Volume Settings
Change or disable the volume of the acoustic warnings made by the Twist.
Automatic Diagnostic Data Collection
With your Twist connected to the Webapp, you can use this
feature to automatically collect diagnostic data.
This can be used to allow Klaxon to help you with any issues you may have with your Twist
remotely.
After you start the Diagnostic, all actions you perform with your Twist will be saved and the
data will be sent to Klaxon servers when the Webapp is connected to the internet again.
The data collected using this feature is not shared with any third party and it is only analyzed
by Klaxon.
Automatic diagnostic data collection
is currently running. The system will
save in the webapp the data relative to the diagnostic session.
To end the session press the button below or shut down the Twist.
The data will be sent to the Klaxon servers when the
Klaxon Webapp is
connected to the internet again.
Wifi Access Point settings
Set a new WiFi SSID for your Twist Access Point. The WiFi password
will
not change.
New WiFi SSID
does not meet the requirements
New WiFi SSID does not meet the requirements
Display Settings
Change the display settings for the Klaxon Webapp.
Select the unit of measurement for distance and speed.
Using this page it is possible to test the hardware of the Twist and the commands. Please refer to the
maintenance manual for instructions on how to operate and read this page.
After performing diagnostics on the user's Twist it is necessary to restart the device before it is used
again.
Drive
Serial Number
-
Average time delta (ms)
-
Number of packets received
-
Speed (km/h)
-
Current (A)
-
Battery (V)
-
Analog Input 1
-
Analog Input 2
-
Digital Input 1
-
Digital Input 2
-
Digital Input 3
-
Digital Input 4
-
Digital Output 1
-
Digital Output 2
-
Master
Battery
-
Card Detect pin
-
SD Card Test
-
Handlebar
Average time delta (ms)
-
Number of packets received
-
Analog Input
-
Brake
-
Battery
-
Charge
-
Push Button
-
USB State
-
Battery Temperature
-
Base command
Average time delta (ms)
-
Number of packets received
-
BRAKE1
-
BRAKE2
-
BACK1
-
BACK2
-
FRONT1
-
FRONT2
-
Battery
-
Charge
-
Push Button
-
USB State
-
Battery Temperature
-
CSV per valori derivata corrente
Time
Message
Diagnostic mode
Do you wish to enter diagnostic mode? After the diagnostic is completed it is necessary to
restart the device ATTENTION: This page is optimized to be viewed from a computer
screen